DESCRIPTION
Medium viscosity, thixotropic, rigid epoxy resin with excellent physical properties. Fast wetting of reinforcement materials. Use 1310T where resistance to draining or run-off is desirable. Pigment will not separate from the system on storage. 100% solids, highly resistant to crystallization in cold environments. No VOCs and DOT non-regulated.
SUGGESTED USES
| Viscosity: | 1,500 – 1,700 cps |
| EEW: | 190 – 196 |
| Color: | Gray liquid |
| Weight/Gal: | 9.62 – 9.70 |
Recommend Rhino 1310T-Gray be used between 65° – 85°F (product and ambient temperatures). Use below 45°F requires special hardener selection, consult with Rhino sales personnel for low temperature recommendations. Remove all surface contaminates such as water, dirt, rust, and petroleum products. Mold surfaces must be waxed or otherwise “released” prior to epoxy application. All Rhino curing agents are compatible with Rhino 1310T-Gray so proportion resin and hardener in accordance with the selected Rhino hardener. Mix resin and hardener for 3 – 5 minutes being certain to scrape the bottom and sides of the mixing container. Mix no material than may be applied before the expiration of the pot life.
Rhino 1310T-Gray cures overnight at typical ambient temperatures (65° – 85°F). A mildly elevated cure dramatically speeds hardness development, see hardener data for specific cure schedules and properties.
