There are two choices. If you are looking to become an OEM or an applicator, you are required to purchase a complete high pressure or low pressure application system. If you wish to have a licensed Rhino Linings applicator spray your application, you do not need to purchase a system.
This means that no solvents (VOCs) are used to dissolve, carry or reduce the coating. Additionally, the resin converts to a solid after mixing with isocyanate.
Our formulations come in 55-gallon drums.
Generally, a surface must be prepped or etched to give it a sufficient profile and then a primer is applied. This assures that the coating has maximum adhesion.
Yes. Dispersing aggregate into the formulation can increase the non-slip properties of the lining.
No. Our products can only be sprayed by a licensed Rhino Linings applicator to assure quality results every time.
Our formulations are tack free within 40 seconds and are completely set after 24 hours.
Yes. Rhino Linings application equipment can be used to cast or spray materials up to a thickness of up to several inches. Our special casting formulation has a slightly slower gel time in order to allow the material to self-level as it is curing.
Absolutely! Our formulations contain no or low VOCs and no CFCs.
Click here to view Product Usage Comparison Chart (PDF)
Not at all! Our 100% solids formulations are tack-free within 40-seconds, resulting in little downtime.
Yes. However, Rhino Linings is meant to be a permanent lining.
No. Rhino Linings are available in a variety of colors.
When subjected to constant UV exposure, Rhino Linings may fade. However, Rhino Linings offers a UV topcoat capable of protecting your lining from UV damage.
Yes. Rhino Linings can be textured from fine to heavy. Aggregate can be added to your lining to provide increased slip-resistance.
Our formulations are designed to withstand temperatures between – 40° and 175°F. Rhino Linings were designed to withstand abrasion, impact, corrosion, vibration, expansion, contraction, flexing and chemical wear.
Rhino Linings can be applied to metals, concrete, fiberglass, some plastics, wood, geotextile, polyurethane surfaces and more.
Rhino Linings can be sprayed or cast from 1/8″ to virtually any desired thickness.
Rhino Linings are applied through our proprietary low-temperature, low-pressure SprayCast systems.
Yes. In addition, a red “wear layer” can be incorporated beneath your lining so that you will know when reapplication is needed. This is typically used in mining applications.
Open Cell Advantage
Interlocking air bubbles expand over 100 times their original size in about 4 seconds to create a soft, spongy, insulating barrier. Open cell spray foam insulation costs less per job and per R-value measurement allowing you to use much less material to cover more ground.
Open-Cell Content
View Our Other Rhino Linings® Industrial Products
View Our Other Rhino Linings® Industrial Products
Spray Machines
Construction Equipment
